BAOHUA EH600 6T In-Ground Wheel Alignment Hydraulic Scissor Lift

BAOHUA's wheel alignment hydraulic scissor lift provides a 6,000 kg main lifting capacity and a separate 4,000 kg secondary jack for alignment and vehicle-maintenance bays. The main platforms are 5,000 mm long and 670 mm wide, with a listed lifting height of 2,080 mm and minimum height of 330 mm.

Hydraulic operation is powered by a 3 kW motor; the secondary jack has a listed lift height of 425 mm. Match the platform arrangement to the vehicles and alignment equipment in the workshop, and confirm foundation requirements, electrical supply and access clearances before installation.

Planning a wheel alignment bay

Provide the largest vehicle weight, wheelbase, track width and ground clearance when specifying this 6 ton wheel alignment scissor lift. The main lift and secondary jack have separate ratings of 6,000 kg and 4,000 kg; their capacities must not be added together. Confirm the secondary lifting points and required access for the intended wheel alignment or underbody service.

The 5,000 mm platform length is a runway dimension, not the complete workshop space requirement. Send the bay plan with vehicle approach, ceiling clearance, alignment-equipment position and electrical supply details, and request the installation and foundation drawing for the final configuration before preparing the floor.

Standard equipment and separately supplied alignment equipment

EH600 includes rear slip plates and the 4,000 kg secondary scissor lifting section as standard. Front wheel turnplates are not included with this in-ground lift; they are supplied with the separately purchased wheel alignment system. The 3D wheel alignment machine is not included in the lift package.

EH600 can be paired with 3D wheel alignment systems. Plan the camera or sensor position, vehicle approach and required clearances around the selected aligner. An external air compressor is required for pneumatic unlocking.

EH600 foundation drawing

The downloadable EH600 drawing shows two pits, each 5,300 mm long and 750 mm wide, with a pit depth of 330 mm. It shows an 850 mm gap between the pits and a 2,350 mm overall outside width. These are foundation dimensions, not the complete workshop or camera operating space.

The drawing requires a concrete base thickness of at least 200 mm and recommends 50 × 50 angle-steel edging around the pits. It marks reserved conduit of 100 mm diameter, drainage positions and 16 M18 × 150 expansion anchors. Pit depth and concrete base thickness are separate dimensions; do not treat the 330 mm pit depth as the concrete slab thickness. Follow the complete drawing for conduit routing, control-unit positioning and anchor positions.

The drawing does not specify the concrete strength grade or a reinforcement design. Confirm these site requirements and the selected alignment-system layout before construction. Current EH600 lifting capacities remain 6,000 kg for the main lift and 4,000 kg for the secondary section; the older operating manual remains a legacy installation reference.